Pygmy led bulb

I bought it with no emissions on it what so ever, has an egr delete plate, and. So now I have a check engine light, Has anyone ever tried to put a resistor in place of the old egr to trick it into. I have those parts somewhere but there seemed to be. Mar A small circuit (consisting of two resistors and a diode) is hooked-up to the wiring harness going to the ECU.

One 1kΩ resistor acts as (the load of).

Could you use some sort of resistor to remove the fault code? So I started in the same area as my. Oct Where do you place the egr resistor for the egr resistor mod, i have searched.

Many people have deleted this stuff. Jan posts – ‎authors Om6swirl valve delete – Gioielleria Benedetti an. Resistor Mod for Swirl Motor Delete Hi All, I am sure this has been done already but I could not. IH8MUD Forum forum.

Series Techforum.

Colorado_Als_EGR_moddiysprinter. Additionally, I used a 1. Mitsubishi Triton Ford Ranger Mazda Isuzu Diesel VW. Jan Will blocking of the egr valve increase or decrease egt?

The difference is night and day! The SUV is a whole new beast now!

Probably the single 6. Aready done the swirl resistor mod a couple of weeks ago was getting mpg on long runs but I have a. Jan i havent put in a resistor or anything else. This section explains why the resistor on the Intake Air Temp (IAT) sensor wire is not a good. These might help when removing the.

The ambient air temperature, at the MAF sensor. Nov I have seen a few threads about the basic stuff like buying or making the plates and where to place them as well as the resistor to insert so you. The cheapest way is to solder a resistor onto the sensor harness.

The resistor mod "should" only keep your egr close not affect the egr positioning as recorded by the ecu. So if it was stuck in a funny position. Apr Any update no issues since the mod ?

Im basically on the same boat. Also what pins did you jump with the resistor ? Oct I looked up and down on the VFAQ. Im also looking for the directions to install the. EGR removal section is.

This mod costs NOTHING, and takes about a half hour with basic tools. I think the mod on my 6. TD was like a $resistor at Radio Shack.

May Purpose: To prevent check engine light from turning on after performing any egr mod. I try to explain in other post. Put the resistor inside the heat shrink tubing and crimp the connectors on.

I would choose the Ford pin. EBPV 4Ohm Resistor Mod. Apr ive heard of people wiring in resistors to make the computer happen when you delete all the smog crap.

With all the mods I have done to my car, my Check Engine still functions.